OUR SERVICES AT A GLANCE:
- Reverse engineering of complete modules and devices (mechanics and electronics)
- Component measurement by optical 3D measurement with a 3D digitizer
- Computed tomography (porosity or damage analysis, assembly-, defect-, material-analysis, verification of the CAD model)
- Creation of prototypes from mechanically produced individual parts to state-of-the-art 5D printing
- Qualifications according to customer requirements in our in-house, independent, accredited environmental simulations laboratory
- Complete documentation according to customer requirements, VDA 6.3 or PPAP
Project 2015063 – side support and idle switch
Type: 248, R65
Figure: Original component (left) and reproduction (right)
Project 2017023 – Hazard warning switch
Type: 114, E3, E9, E24
Figure: Original component (left) and reproduction (right)
Project 2016097 – button for mirror adjustment switch
Type: E23, E24, E30, E32, E34, E36, Z1, Z3
igure: Original component (left) and reproduction (right)
Project 2016097 – Rosette for centerpiece
Type: E3, E24, E23
Figure: Original component (left) and reproduction (right)
Project 2017042 - Decorative strips
Type: E9, E24
Figure: Original component (above) and reproduction (below)
Project 2017074 - Rear window fan E36
Type: E36
Figure: Original component (left) and reproduction (right)
Project 2017075 - Button for radio E36
Type: E36
Figure: Original component (left) and reproduction (right)
Project 2017078 - Push button E36
Type: E36
Figure: Original component (left) and reproduction (right)
Project 2017080 - Initiator
Type: E23, E24, E28, Z1
Figure: Original component (left) and reproduction (right)
Project 2017108 - Front seat adjustment button
Type: E52, Z8
Figure: Original component (left) and reproduction (right)
Project 2017115 - Connector holder
Type: E36, Z3
Figure: Original component (left) and reproduction (right)
Project 2017 128 – Rear window switch
Type: E36, Z3
Figure: Original component (left) and reproduction (right)
Project 2017036 - Bumpers, bumper horns
Type: 2002
Figure: Original component (left) and reproduction (right)
Project 2018067 - Fuel cap not lockable
Type: E3, E21, E26, E30
Figure: Original component (left) and reproduction (right)
Project 2017117 - Moldings
Type: 2002
Figure: Original component (left) and reproduction (right)
Project 2017131 - Bumper and trim strips "Package II"
Type: 2002
Figure: Original component (left) and reproduction (right)
Project 2017134 – Front bumper insert, center
Type: E52, Z8
Figure: Original component (left) and reproduction (right)
Project 2018191 - Decorative grille
Type: E9
Figure: Original component (left) and reproduction (right)
Project 2019037 - Front mask
Type: E30
Figure: Original component (left) and reproduction (right)
Project 2018178 – Brake carrier plate
Type: T4
Figure: Original component (left) and reproduction (right)
